Using PDFCreator since years ;-)
Just installed 0.9.2 on Windows 2003 STD SP1.
Everything works fine excpet i got all prints just like without the left margin: the page prints ok but everything is left-shifted...
Any ideas?
I never hear about this problem. You are the first. So I don't know what it is to do. :-(
Possible that your pagesize settings for the left margin is 0. Please check it.
I have the same problem. Everything is positioned all the way to the left edge, and all the way to the top edge of the page. I've been searching but I can't find any where to manually set any of the margins. could I get a quick hint as to where I can set the margins? Thanks for any help.
I have the same problem. Everything is positioned all the way to the left edge, and all the way to the top edge of the page. I've been searching but I can't find any where to manually set any of the margins. could I get a quick hint as to where I can set the margins? Thanks for any help.
Sorry for the double post. My internet died and I didn't think it uploaded the first time so I hit the 'Post comment' button again to make sure.
Upon further investigation it would seem that for me, if I print from a program with internal margin settings (i.e microsoft office, openoffice or any other program where you can controll the page layout) then PDFCreator retains the margins properly and prints properly. The problem is printing from an application where there is no internal controll over margins (the program I was having problems with has the page layout hard coded and cannot be changed). PDFCreator seems to defaults to the upper and left edges of the page when presented with this condition. I was looking for something similar to a "center page" option for such a situation but I'm thinking one dosn't exist? (correct me if I'm wrong). Anyway, I was able to figure out how to manually adjust the margins for the application I was having problems with in its print settings that I had not seen before so all is good for me now. Sorry I couldn't be of more help to the original poster.
I have the same problem. This software is great and is grat it exists under GPL licence. It would be better if the future versions would have the margins option.
What happens if you print a demo page with wordpad? Are there any margins?
Have the same problem. The margin is adjusted 1cm nearer to the left as it should. (0.9.3).
Even after assigning the paper size to A4 nothing is changed. This doesn't happen with acrobat writer.
For the document it would be usefull to have an adjustment for the margins in general.