DWG2pdf
Submitted by fmelo on Fri, 2008-01-11 15:46.
Hi
When i use autocad and make a pdf file with pdfcreator 9.5, i get this error and two pages
ERROR: syntaxerror
OFFENDING COMMAND: --nostringval--
STACK:
/Title
()
/Subject
(D:20080111120410+00’00’)
/ModDate
()
/Keywords
(PDFCreator Version 0.9.5)
/Creator
(D:20080111120410+00’00’)
/CreationDate
(fcmelo)
/Author
-mark
Any help for that.
Regards
Fernando
Hi Guys,
I just installed this and noticed this only happens with dwg files (well so far!)
I think its not that your putting a ()/\ in the title its that there is no title (nostringval).
So I set a default title in the registry. Depending on your version of windows and if its a standard or server install you need to go to one of the following registries.
Standard Install: HKCU\Software\PDFCreator
Windows 200 or above: HKU\.DEFAULT\Software\PDFCreator
Server Install: HKLM\Software\PDFCreator
For those of you that don't know how to get to the registry. Click start, Run then type regedit, then click ok.
Once you get to the appropriate registry click on Printing then on the right find "StandardTitle". Double click it and put a title in the Value Data. Remember no () or /\. I just put my name.
Then it worked fine. Hope this helps.
Now to figure out the rotating issue!!!
Cheers
B